Back to Frame Machines Index

Anchoring Systems & Adapters

AP-TL-7F - Frame Master Truck Anchoring System

Truck Anchoring For The Floor. Step into the 21st century with the capability for frame vehicles made easier and faster than ever with a Frame Master. This system takes you an average time of 10 to 20 minutes to hook up! You still must tie a chain at the rear to keep the vehicle from moving forward. Production increased by 10-35 percent with less comebacks!

AP-TL-7C - Truck Anchoring System for Chief Machines

Holds the frame sideways, built for any drive-on, chaining lengthwise is easy and the stands are available for most racks and floor pull systems.

AP-TL-7KB - Truck Holding for any Rack

(4) Adjustable Tracks and (4) Adjustable Stands - Multiple width adjustment to fit any frame. Stand and/or top can be reversed for your holding needs. AP-TL-7GT center tubes are interchangable with this holding system.

Truck Anchoring Center Tubes

Offset heads were designed for those hard to reach areas and to get the equipment out of the way of your measuring system. Heads can be purchased individually or as a set.

AP-TL-7ST - Standard Top	AP-TL-7GT1 - #1 Offset Head
AP-TL-7GT2 - #2 Offset Head	AP-TL-7GT3 - #3 Offset Head
AP-TL-7GT - Offset Head Set (Includes Offset Heads #1, #2 and #3)

Unibody Clamping Adapters

AP-BL-173BC - BMW/Corvette Adapters	AP-BL-173M - Mercedes Adapters
AP-CH-ATS - Chief Adapter Tubes Short	AP-CH-ATT - Chief Adapter Tubes Tall
AP-BL-73HV - Horizontal & Vertical Superior Pinch Weld Clamping Jaws

Back to Frame Machines Index