To place order Click on Model Links, fax or mail us order form or lease application, or use our contact information.

Back to: Recycling/Waste Management or Waste Oil Heaters Index. Printer Friendly Version

Patented Waste Oil Burners INOV8 offers two burners both capable of burning a wide variety of waste oils in the safest design available. The patented technology allows the burning of waste oils regardless of viscosity or flash point. The pre-heater heats the oil to a temperature where all oils reach the same viscosity. The pump circulates this oil around the heating element through small tubes at a rate of three feet per second. This prevents burning of oil that typically occurs in competitor designs. The burned oil resembles hard black pieces that will block in a nozzle and cause shutdowns. Burner Specifications Burner Technology Typical Installations Why INOV8? Return on Investment Calculator Stack Emissions Model B200 Burner - The B200 ranges in size from 100,000 to 600,000 BTUs. It has been used for thirteen years in three furnaces and six boiler sizes. It is also the burner that is used with the evaporator and wood fired furnace. It has proven to be highly reliable in all of these applications. Model B700 Burner - The INOV8 B700 ranges in output from about 700,000 to over 1,000,000 BTUs. It has been successfully used in large building applications where there is a high heat load requirement. It has all of the features of the smaller burner. This system also allows the oil to be preheated to a higher temperature providing two benefits: the ability to burn the higher flash point oils like synthetic and vegetable oils and to burn all of the hydrocarbon molecules in the oils for complete and clean combustion with no smoke. The patented needle assembly seats into the nozzle during each shutdown keeping the oil sealed within the system and keeping the nozzle clean. Safety has been a critical element in the design of the INOV8 burners. We use a Fireye industrial rated combustion control suited for the "unpredictable" nature of waste oil. It monitors the flame and delivers the oil only when everything is working properly. Competitor burners use a combustion control intended for residential fuel oil, which is very "predictable" by comparison. Another strong feature is the ease of servicing the INOV8 burner. All components are modular in design such that they can be changed out easily if there is a failure. The two burners are adjustable with minor changes to the oil pressure and perhaps a nozzle change that allows us to offer BTU outputs ranging from 100,000 to 1,000,000. Patented Burner Features: Oil heated at high velocity to prevent shutdowns caused by coked oil Vapor removed from oil provides steady and complete combustion Hydraulic system allows burning a wide variety of oil viscosities Filtration of heated oil prevents nozzle blockage and shutdowns Needle seals nozzle to prevent dripping & provide instant starts Modular design provides ease in servicing and minimal downtime

Back to Top

Auto Lifts • Tire Changers • Wheel Balancers • Brake Lathes • Pipe Benders • Paint Booths
Frame Machines • HVAC • Service Jacks • AC Service • Site Map • Helpful Resources • Links