Photo Gallery (5 photos)

Call for price

The B700 ranges in output from about 700,000 to over 1,000,000 BTUs. It has been successfully used in large building applications where there is a high heat load requirement. It has all of the features of the smaller burner.

• FEATURES
  • Tested Fuels
    • Grade 2 Oil
    • Used Crankcase Oils
    • Transmission and Hydraulic Oils
    • Crankcase oil with 10 percent gasoline
    • 90 Weight Gear Box Oil
    • Mineral Spirits Solvent
    • Machine Shop Cutting Oil
    • Vegetable Oils
  • Additional Fuels
    • Synthetic Oils
    • Commercial and Military Jet Fuels
    • Grades 1, 3 and 4 Heating Oils
  • Industrial Safety Controls
    • Fireye Conbustion Control
    • Ultra-Violet Flame Detector
    • 90 second pre-purge
    • Continual proof of atomizing air
    • Continual proof of combustion air
    • Safe-start sequence
    • 10 second Trial for ignition timing
    • 3 second Flame failure response timing
    • Safety shut-down indicator
    • Fuel shut-off by electrically operated valve and mechanically driven needle in oil nozzle
    • Line voltage thermostat controlling all burner power
    • Aquastat (determined by installer) : not supplied

• SPECIFICATIONS
  • Dimensions (l x w x h) : 25" x 24" x 19"
  • Compressed Air Requirements
    • CFM : 2
    • PSIG : 40
  • Air Connection : 1/4 NPT
  • Flame Length : 5' - 7'
  • Flame Diameter : 18"
  • Mounting Flange : Standard 3 bolt pattern
  • Diameter of Air Tube : 5"
  • Length of Air Tube : 4-1/2"
  • Convenience Controls
    • Additional attempts to establish flame
    • Automatic nozzle clean-out
    • Hour meter
    • Dirty filter indicator
    • Switch to test spark ignition
  • Electrical
    • Total current draw : 16 amps
    • Volts : 120
    • Required circuit protection : 20 amps
    • Frequency : 60 Hz
    • Thermostat Voltage : 120
    • Ignition Transformer, 23 ma secondary, continuous duty shielded transformer : 10,000V
    • 10 second Intermittent spark ignition
  • Burner Motor
    • Horsepower : 1/3
    • RPM : 3,450
  • Fuel Pump : Suntec Model A2RA Waste Oil Pump
  • Oil Nozzle : Delavan Aspirated Nozzle - 30609
  • Pump Connection : 1/4 NPT
  • Fuel Consumpion : 4.6 to 7.2 gallons per hour
  • BTUH - Input(x100) : 650 to 1.1M
  • Equipment Included
    • Vapor elimination from oil
    • Filtration after oil heating
    • Heater Switch
    • Line voltage thermostat
    • Floating oil pickup assembly
    • Check Valve
    • Return flow vent system
    • Installation and Maintenance Manual
  • Optional Equipment
    • Boost pump
    • Draft Inducer (sized per application)
  • Shipping Weight : 72 lbs.
  • Warranty : One year full warranty on parts (not labor)